Dect Interface Settings - Avaya DECT R4 Installation And Administration Manual

2. Click Next until you reach DECT IP Address.
3. Set multiple Locations (former IP regions) to yes.
4. Do not enter any IP address or remove the entries for the DECT IP-Address and for the
secondary DECT IP-Address
Note:
Of course a multi AIWS configuration with splitting services of the AIWS to
Note:
several Elise hardware units is supported in the same manner, see
configuration

DECT Interface settings

The DECT Interface controls the messaging flow between the Cordless Telephone System and
the AIWS services.
General Settings
To find DECT General Settings, do as follows:
1. On the AIWS start page, select Configuration. The AIWS Configuration page opens.
2. Select Other Settings > Advanced Configuration. The AIWS Advanced Configuration
page opens.
3. On the AIWS Advanced Configuration page, select General Settings under DECT
Interface.
Call Diversion Display Text
●
When this parameter is enabled, the text specified is added to the display message when
a call diversion takes place. The original Call ID can be included in the parameter text by
writing a % character where the Call ID shall be inserted.
Advanced parameters include:
Extended Activity Log
●
N/A
Broadcast
●
Specifies whether broadcast messaging is allowed or not. Only IP-DECT systems can
handle broadcast, all other systems will ignore the parameter.
Set time in DECT
●
N/A
Priority conversion
●
Used to convert messaging priorities; Alarm, High, Normal and Low. This conversion is
normally only used for compatibility with some PWT telephones and should never be
enabled unless you are absolutely sure.
Avaya DECT R4 - Installation and Maintenance Guide
on page 369.
DECT Interface
Multiple AIWS
441
02/2016