Avaya DECT R4 Installation And Administration Manual page 582

Installing Elise 3 Server (AIWS2 Hardware)
Note:
The reserved IP address for accessing the Elise 3 Server (AIWS2 Hardware)
Note:
through the management port is "192.5.36.229".
Note:
A port driver must be installed on your PC to get access through the management
Note:
port.
The default mode for the management port is Network access but the Mass storage mode is
used to get the required driver for the module. When set to Mass storage, the module will
automatically change to the Network access mode within 10 minutes. By pressing the Mode
button twice, the Management port toggles from Network access to Mass storage mode and
the other way around.
The Mass storage mode is only used when the driver, required for accessing the module
through the management port, shall be installed. This mode is utilized only when the PC is used
for the first time.
1. Connect a mini-USB type B cable between the USB port on your PC and the
management port on the module.
Note:
If the required port driver is not installed on the PC, install it now. The installation
Note:
differs and is dependent on the operating system. See either
driver on Windows XP/Vista
Windows 7
2. Open a web browser on your PC and enter the IP address "192.5.36.229" in the address
field to access the products web interface.
3. Continue the basic configuration steps. See
Installing the port driver on Windows XP/Vista
Note:
When switching between Mass storage mode and network mode, it takes about
Note:
30 seconds before the module can be accessed with the 192.5.36.229 address.
582
Avaya DECT R4 - Installation and Maintenance Guide
on page 582 below or
on page 584.
Installing the port
Installing the port driver on
Basic configuration on page 586.
02/2016