Avaya DECT R4 Installation And Administration Manual page 133

Figure 40: Configuring the SNMP settings
1. Select General > SNMP
2. Enter a name in the Community field if you are not using the standard community name
(public). The community text string acts like a password to regulate access to the agent on
the Base Station.
3. Enter a device name in the Device Name field. This field is optional and serves only
informational purposes.
4. Enter the name and phone number of the contact person in the Contact field. This field is
optional and serves only informational purposes.
5. Enter a location in the Location field. This field is optional and serves only informational
purposes.
6. Select the Authentification Trap check box to enable the sending of authentification
traps. To gain access through SNMP, enter the correct Community Name. If enabled, the
system generates a trap to prevent access with an incorrect Community Name.
7. Enter the IP address of the desired trap destinations in the Trap Destinations field. SNMP
traps are sent to all destinations.
8. Enter the IP address and mask of the networks that have the permission to send SNMP
requests. If the field is empty, all networks can send SNMP requests.
9. Click OK.
Certificates
The Certificates tab is part of IP Security in IP-DECT. For more information on IP Security, see
chapter IP security
Avaya DECT R4 - Installation and Maintenance Guide
on page 76.
Operation
133
02/2016