Avaya DECT R4 Installation And Administration Manual page 189

MEM
Concurrent calls
Temperature (applicable only for
IPBL)
Voltage (applicable only for IPBL)
Current (applicable only for IPBL)
1. Select Diagnostics > Performance
2. Select the check box(s) for the desired performance statistics.
3. Click OK.
One window shows statistics for the last 24 hours. The maximum possible value is displayed in
the top-left corner. Click the left or right arrow buttons to see different time frames.
Config Show
Under Diagnostics > Config Show, the configuration is displayed as a text output.
Ping
The ping function is used to determine the response time from the IPBS/IPBL to a certain IP
address. It can be used to analyze the connection between the IP-DECT system components.
1. Select Diagnostics > Ping.
2. Enter an IP address in the IP Address text field.
3. Press Enter on the keyboard.
Traceroute
The traceroute function displays how packets travel from the IPBS to a certain IP address. The
result is an ordered list of IP addresses with the measured round trip time.
1. Select Diagnostics > Traceroute.
2. Enter an IP address in the IP Address text field.
3. Press Enter on the keyboard.
RFP Scan
This section only applies to the IPBS.
Avaya DECT R4 - Installation and Maintenance Guide
Shows memory utilization
Shows the number of ongoing calls
Shows the temperature of the cabinet.
Shows the power supply voltage level
Shows the power supply current consumption
Operation
189
02/2016