Install The Port Driver On Windows Xp/Vista - Avaya DECT R4 Installation And Administration Manual

4. When the starting up indication has stopped, open a web browser on your computer and
enter the IP address "192.5.36.229" in the address field to access the products web
interface.
5. Continue the

Install the Port Driver on Windows XP/Vista

Note:
When switching between mass storage mode and network mode, it takes about
Note:
30 seconds before the module can be accessed with the 192.5.36.229 address.
1. Connect a mini-USB type B cable between the USB port on your computer and the
management port on the module. The Found new hardware wizard opens but at this stage
a valid USB port driver is not available, so close the wizard and continue to install the
driver.
2. Press the Mode button twice to change the mode to mass storage. The module will now
turn up as a mass storage device on your computer. This is indicated by slow flashing blue
light on the Mode button LED.
3. Locate the required "elise3.inf" driver and save it on your computer.
4. Press the Mode button twice again to change the USB mode to network access. The
Found new hardware dialog box opens.
5. Select No, not this time and click "Next".
6. Select Install from a list or specific location (Advanced) and click "Next".
7. Select Search for the best driver in these locations.
8. Check the Search removable media (floppy, CD-ROM...) check box.
9. Check the Include this location in the search: check box.
10. Browse to the folder where the port driver is saved.
Avaya DECT R4 - Installation and Maintenance Guide
Configuration on page 513.
Software administration on the AIWS2
511
02/2016