Avaya DECT R4 Installation And Administration Manual page 286

Installing Multiple Battery Charger
Required Tools etc.
Screwdrivers
●
Cutting pliers
●
Multimeter
●
Screws and wall plugs for wall mounting. Make sure the screws and wall plugs have the
●
correct length for the type of wall used. See example below:
Wall material
Single plasterboard
Double plasterboard
Concrete
Examples of Ways to Mount the Battery Pack Chargers
The following picture shows different ways to mount Multiple Battery Charger. It is possible to
set up different combinations of Multiple Battery Charger and Rack Chargers.
Installation steps
The installation is done in two steps:
1. Wall mounting.
2. Electrical installation.
Wall mounting
First, make an outline of how the battery pack chargers are to be placed.
Tip:
If several Multiple Battery Charger (or Rackmount Chargers) are to be mounted
Tip:
close to each other, mount them so that there is enough space between then to
be able to disconnect the batteries or the telephones (vertical distance) and to be
able to open the top cover (horizontal distance).
Tip:
When you are planning the location of the modules, start to mount them in a
Tip:
height that makes it easy to reach the batteries.
Measure and mark the drill holes by using the dimensions in
battery pack charger on the wall with four screws.
286
Avaya DECT R4 - Installation and Maintenance Guide
Plug length Screw diameter
Thorsman TP1 3.5 – 5 mm
Thorsman TP2 3.5 – 5 mm
Thorsman TP2 3.5 – 5 mm
figure 63. Drill and fasten the
02/2016