Message Distribution - Avaya DECT R4 Installation And Administration Manual

4. On the time settings page, enter when the Elise 3 Server (AIWS2 Hardware) should send
its time to System 900 in the "Time push time" field.
5. Click "Setup System 900 time".
6. Select "Yes" in the "Set time in System 900".
Setting time in other carrier systems is done similarly. If several carrier systems are available,
the time will be sent at the same time to all systems.
Time Synchronization
It can take a few seconds to synchronize the date and time during start up or if the IP address to
the time server has been changed.
When the time is changed in the time server, it can take up to 30 minutes to synchronize the
time, depending on how the modules are set up and how they are connected together.

Message distribution

In the administration pages, there are distribution lists that are used to distribute incoming
information to other modules. If a module is to be connected to several carrier systems, for
example both System 900 and a Cordless Telephone System, distribution of incoming data from
the different systems has to be configured independently. The distribution of "Status Logs" and
"Activity Logs" are configured separately. Advanced activity settings for activity logs are
described in the Function Description, Activity Logging in Unite,TD 92341GB.
The addressing is described in the examples below:
Addressing a module on the System 900 A-bus
When a specific module on the A-bus is addressed, the data will be transferred directly to that
module. It is however not necessary to address a specific module on the A-bus as the Central
Unit in the System 900 can distribute the data to a module. Note that this requires configuration
of the Central Unit.
No module addressing
●
127.0.0.1/S900
The data is sent to the System 900 interface in the Elise 2 Server (AIWS Hardware), which
sends the data on the A-bus without the module address defined. The Central Unit in the
system has to be configured to distribute the data to a module. It is also possible to
address the System 900 interface on another module by entering its IP address instead of
127.0.0.1 (localhost).
Module addressing
●
127.0.0.1/S900?03
Avaya DECT R4 - Installation and Maintenance Guide
Installing the Elise 3 Server (AIWS2 Hardware)
589
02/2016