Avaya DECT R4 Installation And Administration Manual page 302

Installing and operating the Rackmount Charger
Figure 72: CR3 with IEC C14 connector and an extension cord with an IEC C13 connector.
Proceed with the Communication cable connection when required.
Installation test
1. Connect the mains power supply cord to the wall socket.
2. The LED on the front of the charger shall now light up.
Power supply by fixed connection
Note:
If the rack charger shall be connected with a fixed connection, the AC connection
Note:
must be done by a authorized electrician.
Tip: It is possible to use any one of the two AC terminal blocks for AC input. Consequently, the
unused terminal block may be used to connect the next rack charger or battery pack charger.
The Power Supply module connects to 100-240VAC/0.7A 50/60 Hz. When working with the
units the mains power supply cable must always be disconnected. The safety covers must be
mounted on top of the power supply terminal blocks to prevent hazardous situations, like
electric chock.
302
Avaya DECT R4 - Installation and Maintenance Guide 02/2016