Avaya DECT R4 Installation And Administration Manual page 143

The bridges in the network should support RSTP.
●
LAN1 and LAN2 should be connected to RSTP enabled bridge ports.
●
LAN1 and LAN2 should be connected to different bridges.
●
LAN1 must be configured for a static IP address. See
●
page 141.
Select LAN1 > IP. Make sure that the Check ARP and the Disable check boxes are
●
unchecked.
Select LAN2 > IP. Select the Disable check box.
●
Select LAN2 > DHCP. Select disabled in the Mode drop-down list.
●
Select LAN1 > VLAN. Check that VLAN is not enabled.
●
Select LAN2 > VLAN. Check that VLAN is not enabled.
●
To enable RSTP
1. Select LAN1 > RSTP.
2. Select the Enable check box.
3. To trace events triggering RSTP state machine actions and the associated events, select
the Trace Actions check box.
4. Click OK.
Deactivate LAN port (only for IPBL)
To deactivate LAN port:
1. Select LAN2 > IP.
2. Select the Disable check box.
3. Click OK.
The LAN2 port is for administration only and can be deactivated. However when using RSTP
you cannot deactivate the LAN2 port as both ports are required for RSTP.
Avaya DECT R4 - Installation and Maintenance Guide
Setting a static IP address
Operation
on
143
02/2016