Avaya DECT R4 Installation And Administration Manual page 536

Installing Elise 2 Server (AIWS Hardware)
System Installation
When the Elise 2 Server (AIWS Hardware) controls the communication on the A-bus, a
maximum of 15 modules can be connected to the A-bus. The Elise 2 Server (AIWS Hardware)
should have the address 00 and other modules that are connected to the A-bus must have
addresses in the range 01-0F.
See also Message distribution
Required Hardware Modifications
When Elise 2 Server (AIWS Hardware) shall control the communication on the A/B-bus, jumper
points S4 and S5 has to be soldered, see
Figure 173: Jumper points for configuring the Elise 2 Server (AIWS Hardware) unit to be a
communication controller on A/B-bus.
IC1
J4
J22
1
IC24
J9
S3
LED6
LED7
J7
RS232:3
J8
RS232:2
J20
ETH
1 4
J5
536
Avaya DECT R4 - Installation and Maintenance Guide
on page 548 and documentation for the System 900.
SW4
LED1
J1
SW2
BAT1 SW3
J2
J10
J15
S4
S5
J11 J12 J13
RS232:1 900 900
1 4 1 2 1 2
J6 J14 S4 S4
J24
S5 S5
S1
S2
figure 173 below.
02/2016