Unite - Avaya DECT R4 Installation And Administration Manual

UNITE

Configuring messaging
If an AIWS is to be used in the IP-DECT system, enter the IP address following the steps below.
1. Select UNITE > SMS.
Note:
To access the SMS tab, the Master mode has to be activated, see
Note:
Mode
2. Enter the address to the AIWS in the IP Address text field.
3. Click OK.
Device management
If a specific Device Manager (e.g. AIWS2) is to be used in the Avaya IP-DECT system, enter the
IP address to the Device Manager following the steps below. To set the Master to search for an
existing Device Manager on the network, go to
1. Select UNITE > Device Management.
Note:
To access the Device Management tab, the Master mode has to be activated,
Note:
see
2. Enter the address to the Device Manager in the Unite IP Address text field.
The IP address for the Device Manager that the Master is currently connected to is shown
under Active Settings.
3. Click OK.
4. Reset in order to make the changes take effect, see
Note:
However if device management is used the IP-Address of the AIWS needs to be
Note:
configured in the UNITE -> SMS tab as well, see
page 169.
Configuring the location
In a bigger IP-DECT system with offices on several locations it is possible to configure one
Master Base Station on each office.
Avaya DECT R4 - Installation and Maintenance Guide
on page 154.
Selecting Mode on page 154.
Service discovery on page 170.
Reset on page 190.
Configuring messaging
Operation
Selecting
on
169
02/2016