Avaya DECT R4 Installation And Administration Manual page 212

Configuring Avaya DECT phones
!
Important:
Never remove a telephone from the charger until the instructions in the display or
Important:
the LED tells you to do so (see status on the LED if the display is broken). If there
is an error indication it may be allowed to remove the phone, see troubleshooting
Avaya 3720/3725 and 3740/3749 DECT Telephones
instructions.
!
Important:
After the old telephone has been in the charger, the new telephone needs to be
Important:
placed in the charger regardless if the replacement was successful or not. Failing
to do so may result in malfunction and the new telephone will need to be sent for
service.
1. Start the procedure with the new telephone. The telephone shall be switched off. Press
and hold the Off-hook key and in the mean time put the new telephone in the charger. In
charger is displayed.
Hold the key for at least 3 seconds until Start phone replacement? is displayed. The
telephone LED changes to flashing orange. Press Yes.
2. Press OK when the text Follow the instructions. Each step can take several minutes.
appears in the display.
3. When the telephone is ready, the text Please insert old phone in charger appears. The
charger LED changes to quick orange flashing.
Remove the new telephone from the charger. The text Please insert this phone in
charger when old phone is ready. appears.
4. Put the old telephone in the charger (the telephone can either be switched on or off). After
a few seconds, the text Saving settings. Do not remove phone from charger appears.
The charger LED changes to slow orange flashing.
!
Important:
Do not remove the telephone while the text Saving settings is displayed. It may
Important:
take several minutes.
212
Avaya DECT R4 - Installation and Maintenance Guide
on page 681 for further
02/2016