Installing Multiple Battery Charger; Introduction - Avaya DECT R4 Installation And Administration Manual

Installing Multiple Battery Charger

Introduction

This chapter describes how to install, configure and operate the Multiple Battery Charger. It
charges batteries for the Avaya DECT Telephones.
Each Multiple Battery Charger charges six batteries simultaneously.
Figure 62: Multiple Battery Charger
Multiple Battery Charger can be serially connected with up to four Battery Pack Chargers
connected to the same power source.
This chapter is intended as a guide for installation and troubleshooting purposes.
Supply voltage
Building fuse for fixed installation
Installation alternatives
The CR4 as delivered can be installed as a single unit. When installed as a single unit, the
●
power cord with the C14 connector may be used with a suitable extension cord to be
plugged into a wall outlet.
Avaya DECT R4 - Installation and Maintenance Guide
Power Supply for Multiple Battery
Charger
100–240 VAC/0.7 A, 50/60 Hz
10 A
281
02/2016