Avaya DECT R4 Installation And Administration Manual page 592

Installing Elise 3 Server (AIWS2 Hardware)
Factory default settings can also be chosen from the Boot Mode's web interface when new
software is installed or when returning to Normal Operation from Boot Mode, see
software in boot mode
Note:
Network settings (IP address, Host name, etc.) will not be changed.
Note:
Installing software in boot mode
Installing new software is normally done from the application's web interface, refer to the
application documentation. But if the application's web interface cannot be reached it is possible
to put Elise 3 Server (AIWS2 Hardware) in Boot Mode, access the modules web interface and
install new software from there.
Note:
It is not recommended to use the module's Management port when installing
Note:
software.
Two software versions can be installed on the module. One software version is active and the
other inactive in normal operation.
1. Put the module in Boot Mode, see
2. Select Software > Install software.
3. Click the "Browse..." button and locate the software (.pkg) file to install.
4. Select where to save the software. If two versions of the software already have been
installed on the module choose which software to replace.
592
Avaya DECT R4 - Installation and Maintenance Guide
on page 592.
Starting in boot mode
Installing
on page 565.
02/2016