Elise 2 Server (Aiws Hardware) Controlling The Communication On The A/B-Bus - Avaya DECT R4 Installation And Administration Manual

Hide thumbs Also See for DECT R4:

Table of Contents

Figure 172: Jumper points for adjusting the Elise 2 Server (AIWS Hardware) unit to use the

System 900 B-bus instead of the A-bus.

Elise 2 Server (AIWS Hardware) controlling the communication on

Depending on the software application on the Elise 2 Server (AIWS Hardware), it can be used

to control the communication on the A-bus, i.e. the Central Unit is not used for communication

control. This can be useful when System 900 is not used for messaging but only to

communicate with, for example, an Alarm Module or Output Module.

The same information that can be received when the Elise 2 Server (AIWS Hardware) is

connected to an A-bus with Central Unit, can also be received when it is controlling the

communication. Examples of information is input activity and pagings from the Alarm Modules

(see respective software application documentation for more information about the

possibilities). Alarms and Mobile data from cordless telephones can be transferred from the

Elise 2 Server (AIWS Hardware) to modules connected to the A-bus. The Elise 2 Server (AIWS

Hardware) does not have any other of the Central Unit functionality, for example the possibility

to address Pocket Units over the A-bus or handle absence information received from Charging

Avaya DECT R4 - Installation and Maintenance Guide

Installation

Show Quick Links

Table of Contents

Troubleshooting