Avaya DECT R4 Installation And Administration Manual page 305

3. Remove the cover which protects the unused AC output terminal block of the charger
closer to the AC power source.
4. Mount the cable support holder at the unused opening in the charger closer to the AC
power source. The cable support holder is provided in the parts bag. See
Figure 75: The rectangular cover that shall be removed and exchanged with a cable
support holder with a mains power supply cord run through it
5. Remove the C14 connector from the additional charger. Cut and strip the mains power
supply cord coming from the additional charger to the length required.
6. Run the power supply cord from the additional charger through the cable support holder of
the previous charger, see
Figure 76: Securing the mains power supply cable
7. Connect the power supply cord from the additional charger to the unused terminal block in
the charger closer to the AC power source. Note the embossed markings L, earth symbol
and N, see
Avaya DECT R4 - Installation and Maintenance Guide
figure 76
figure 77.
Installation and configuration
figure 75.
02/2016
305