Avaya DECT R4 Installation And Administration Manual page 562

Installing Elise 3 Server (AIWS2 Hardware)
Table 1: Connections, buttons and LEDs on the Elise 3 Server (AIWS2 Hardware)
Front panel
Management
Mode button
SD Card slot
Table 2: Connections, buttons and LEDs on the Elise 3 Server (AIWS2 Hardware)
Rear panel
LAN1
LAN2
S900/S900
A-bus
LON
V+ Ext/GND
562
Avaya DECT R4 - Installation and Maintenance Guide
USB Port 1
1
USB Port 2
2
Mini-USB port for device management See
Elise 3 Server (AIWS2 Hardware) through the management
port (USB) on page 581
A temporary push button with a blue LED.
Used to place the module into specific modes using different
push patterns. See
Server (AIWS2 Hardware)
Currently not used
Modular jacks (RJ45) for connection of 10baseT or 100baseT
Ethernet. See
Currently not used (for future releases)
Modular jacks (RJ45) for connection of A-bus from System 900
with modular system bus cabling, see
System 900 on page 578
Not applicable for the Elise 3 Lite version.
Screw connector for connection of A-bus from System 900 when
modular system bus cable is not used, see
System 900 on page 578
Not applicable for the Elise 3 Lite version
Screw connector for connection of the LON bus, see
Bus on page 579
Applicable for the Elise 3 LON version only
Ext External 12 V power supply to provide galvanic isolation of
the inputs and outputs, see below.
Powering down and restarting the Elise 3
on page 564
Ethernet ports on page 578
Accessing the
A-bus connection to
A-bus connection to
LON
02/2016