Avaya DECT R4 Installation And Administration Manual page 370

Installing and operating the AIWS and the AIWS2
- Set forwarding for NetPage:
In Configuration > Other Settings > Advanced Configuration > Other > UNS >
Operating mode:
Operating Mode shall be set to Forwarding. IP address of forward destination UNS
shall be set to the IP address of the AIWS with the DECT connection (here AIWSB:
192.168.0.2). Click Activate
- Disable the DECT interface on the AIWS A because it's not used. If the DECT
interface is disabled the AIWS will not show any error logs, because of an non
connected DECT interface. Select advanced configuration > general settings >
view advanced parameters. Set DECT interface to disable.
Figure 85: Setting the IP address
AIWS B (Standard)
●
- DECT and Central Phonebook connection are configured in the AIWS Setup Wizard.
- In Configuration > Other Settings > Advanced Configuration > Device
Management:
Remove all IP addresses.
Migration to a double AIWS solution
This example assumes that the original system uses one AIWS Enterprise and this single AIWS
handles both Device Management and the connection to DECT. An additional module, AIWS
Standard shall now be added to the system.
One reason for this migration is to configure the more business critical applications such as
NetPage and Central Phonebook on one AIWS and the less critical application Device
Management on another.
Change the following settings in the original AIWS:
370
Avaya DECT R4 - Installation and Maintenance Guide 02/2016