Replacing An Acx4000 Air Filter; Removing An Acx4000 Air Filter - Juniper ACX4000 Hardware Manual

Replacing an ACX4000 Air Filter

IN THIS SECTION

Removing an ACX4000 Air Filter | 134

Installing an ACX4000 Air Filter | 135
Removing an ACX4000 Air Filter
CAUTION: Do not run the device for more than a few minutes without the air filter in
place.
CAUTION: Do not run the device for more than a few minutes without the air filter in
place.
CAUTION: Always keep the air filter in place while the device is operating, except
during replacement. Because the fans are very powerful, they could pull small bits of
wire or other materials into the device through the unfiltered air intake. This could
damage device components.
The air filter is installed on the right side of the fan tray. To remove the air filter (see
1. Attach an ESD grounding strap to your bare wrist, and connect the other end of the strap to an ESD
grounding point.
2. Remove the fan tray as described in "Replacing an ACX4000 Fan Tray" on page
Figure 7):
137.
134