Rap 2.3.5 The Terminal Does Not Answer; Rap 2.3.6 Mechanical Checkout - Xerox Telecopier 7017 Technical Reference Manual

RAP 2.3.5 The Terminal Does Not
Answer.
1. Phone rings (but does not answer).
Y N
| Go to Step 3.
RX NOTE: Check manual receive is not
selected. Check all Autodialer and System Data
parameters are set correctly (switches, links
and System Data) for your particular country.
2. Replace A10, A2.
3. Disconnect the handset
terminal. Disconnect the data cable from
the telephone wall jack.
handset into the telephone wall jack.
Dial tone is heard.
Y N
| Inform Customer of telephone line
problem.
4. Reseat connectors, then replace data
cable, A10.
Telecopier 7017 / 7017SF

RAP 2.3.6 Mechanical Checkout.

NOTE: The following checks apply to all belts,
gears, pulleys, springs and bearings in these
areas:
• Front and Rear Frames.
• Upper and Lower Scanner.
• Upper and Lower Printer.
1. Remove LH cover.
2. Inspect all drive belts. Belts are in good
condition (not broken, frayed and do not
from the
have surface cracks).
Y N
Plug the
| Replace belt.
3. Inspect all shafts. Shafts turn freely.
Y N
| Replace shaft and bearings.
4. Inspect all bearings. Bearings are secure
on shafts and positioned properly in
frame cutouts.
Y N
| Position bearings in frame cutouts,
replace bearings.
5. Inspect pulleys.
shafts and are not broken.
Y N
| Replace pulley or E-ring.
6. Inspect upper scanner.
closes and latches.
Y N
| Replace latch spring, latches.
7. Inspect upper printer.
closes and latches.
Y N
| Replace latch spring, latches or
printer frame.
www.printcopy.info
10. Return to procedure which directed you
Pulleys are secure on
Upper scanner
Upper printer
12/88
2-11
8. Inspect hold down springs on scanner
shaft bearings. Springs are secure on
bearings and shafts turn freely.
Y N
| Replace springs.
9. Inspect gears. Gears are secure on shafts
and are not broken.
properly.
Y N
| Tighten set screw in gear or replace
gear or E-rings.
to this RAP or go to Final Actions.
RAPS 2.3.5, 2.3.6
Gears mesh