Removal And Installation - Honda 2004 Odyssey Service Manual

Under-hood Fuse/Relay Box

Removal and Installation

SRS components are located in this area. Review the
SRS component locations, '99-01 models (see page 23-
18), '02 model (see page 23-19), '03-04 models (see
page 23-20), and the precautions and procedures (see
page 23-21) in the SRS before performing repairs or
service.
Removal
1. Make sure you have the anti-theft codes for the
radio and the navigation system, then write down
the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable, then
disconnect the positive cable, and wait at least 3
minutes.
3. Remove the driver's dashboard lower cover (see
page 20-69).
4. Remove the door sill molding and left or right kick
panel (see page 20-58).
5. Disconnect the connectors from the fuse side of the
driver's fuse/relay box (A) or the passenger's fuse/
relay box (B).
A
B
6. Remove the mounting bolt release the clips (C) at
the middle on both sides of the box, and pull the
fuse/relay box away from the body.
22-86
7. Disconnect the driver's or passenger's under-dash
fuse/relay box connectors, and remove the driver's
or passenger's under-dash fuse/relay box.
NOTE: Some part of the SRS harness connector is a
spring-loaded lock type (see page 23-25).
Installation
1. Connect the connectors to the driver's or
passenger's under-dash fuse/relay box, then install
the driver's or passenger's under-dash fuse/relay
box in the reverse order of removal.
2. Install the left or right kick panel and the door sill
molding.
3. Install the dashboard lower cover.
4. Connect both the positive cable and negative cable
to the battery, enter the anti-theft codes for the
radio and the navigation system, then enter the
customer's radio station presets.
5. Do the power window control unit reset procedure
(see page 22-200).
6. Confirm that all systems work properly.
C