Selective Qinq Configuration; Selective Qinq Configuration Task List; Enabling The Selective Qinq Feature For A Port; Enabling The Inter-Vlan Mac Address Replicating Feature - H3C S3100-52P Operation Manual

Operation Manual – VLAN-VPN
H3C S3100-52P Ethernet Switch

2.2 Selective QinQ Configuration

2.2.1 Selective QinQ Configuration Task List

Complete the following tasks to configure selective QinQ:

Enabling the Selective QinQ Feature for a Port

Enabling the Inter-VLAN MAC Address Replicating Feature

2.2.2 Enabling the Selective QinQ Feature for a Port
The following configurations are required for the selective QinQ feature:
Enabling the VLAN-VPN feature on the current port
Configuring the current port to permit packets of specific VLANs (the VLANs
whose tags are to be used as the outer VLAN tags are required)
Follow these steps to enable the selective QinQ feature:
Enter system view
Enter Ethernet port view
Configure the outer VLAN
tag and enter QinQ view
Configure to add outer
VLAN tags to the packets
with the specific inner
VLAN tags
Note:
Do not enable both the selective QinQ function and the DHCP snooping function on a
switch. Otherwise, the DHCP snooping function may operate improperly.
2.2.3 Enabling the Inter-VLAN MAC Address Replicating Feature
Follow these steps to enable the inter-VLAN MAC address replicating feature:
Task
To do...
system-view
interface interface-type
interface-number
vlan-vpn vid vlan-id
raw-vlan-id inbound
vlan-id-list
Chapter 2 Selective QinQ Configuration
Use the command...
2-4
Remarks
Required
Optional
Remarks
—
—
Required
Required
By default, the feature of
adding an outer VLAN tag
to the packets with the
specific inner VLAN tags
is disabled.