Setting To Output System Information To The Trap Buffer - H3C S3100-52P Operation Manual

Operation Manual – Information Center
H3C S3100-52P Ethernet Switch
Enter system view
Enable the information
center
Enable system
information output to a
log host
Configure the source
interface through
which log information
is sent to the log host
Configure the output
rules of system
information
Set the format of the
time stamp to be sent
to the log host
Note:
Be sure to set the correct IP address when using the info-center loghost command. A
loopback IP address will cause an error message prompting that this address is invalid.

1.2.7 Setting to Output System Information to the Trap Buffer

Follow these steps to set to output system information to the trap buffer:
Enter system view
To do... Use the command...
system-view
info-center enable
info-center loghost
host-ip-addr [ channel
{ channel-number |
channel-name } | facility
local-number ]*
info-center loghost
source interface-type
interface-number
info-center source
{ modu-name | default }
channel
{ channel-number |
channel-name } [ { log |
trap | debug } { level
severity | state state } ]*
info-center timestamp
loghost { date |
no-year-date | none }
To do...
system-view
Use the command...
1-14
Chapter 1 Information Center
Remarks
—
Optional
Enabled by default.
Required
By default, the switch does
not output information to the
log host.
After you configure the
switch to output information
to the log host, the switch
uses information channel 2
by default.
Optional
By default, no source
interface is configured, and
the system automatically
selects an interface as the
source interface.
Optional
Refer to Table 1-4 for the
default output rules of
system information.
Optional
By default, the time stamp
format of the information
output to the log host is date.
Remarks
—