Configuring To Display The Time Stamp With The Utc Time Zone - H3C S3100-52P Operation Manual

Operation Manual – Information Center
H3C S3100-52P Ethernet Switch
Enter system view
Enable synchronous
information output
Note:
If the system information is output before you input any information following the
current command line prompt, the system does not echo any command line prompt
after the system information output.
In the interaction mode, you are prompted for some information input. If the input is
interrupted by system output, no system prompt (except the Y/N string) will be
echoed after the output, but your input will be displayed in a new line.

1.2.3 Configuring to Display the Time Stamp with the UTC Time Zone

To add UTC time zone to the time stamp in the information center output information,
you must:
Set the local time zone
Set the time stamp format in the output direction of the information center to date
Configure to add the UTC time zone to the output information
Follow these steps to configure to display time stamp with the UTC time zone:
Set the time zone for the
system
Enter system view
Set the
time stamp
format in
the output
direction of
the
information
center to
date
Set to display the UTC time
zone in the output
information of the
information center
To do...
system-view
info-center
synchronous
To do...
clock timezone
zone-name { add |
minus } time
system-view
Log host
info-center timestamp
direction loghost date
info-center timestamp
Non log host
{ log | trap | debugging }
direction
date
info-center timestamp
utc
Use the command...
Use the command...
1-9
Chapter 1 Information Center
Remarks
—
Required
Disabled by default
Remarks
Required
By default, UTC time
zone is set for the
system.
—
Required
Use either command
Required
By default, no UTC time
zone is displayed in the
output information