Qos Profile Configuration Task List; Configuring A Qos Profile - H3C S3100-52P Operation Manual

Operation Manual – QoS-QoS Profile
H3C S3100-52P Ethernet Switch
The switch directly applies the QoS profile to the port the user is connected to.
Note:
A user-based QoS profile application fails if the traffic classification rule defined in the
QoS profile contains source address information (including source MAC address
information, source IP address information, and VLAN information).
II. Manual application mode
You can use the apply command to manually apply a QoS profile to a port.

2.2 QoS Profile Configuration Task List

Complete the following tasks to configure QoS profile:

Configuring a QoS Profile

Applying a QoS Profile
2.2.1 Configuring a QoS Profile
I. Configuration prerequisites
The ACL rules used for traffic classification are defined. Refer to the ACL module
of this manual for information about defining ACL rules.
The type and number of actions in the QoS profile are specified.
II. Configuration procedure
Follow these steps to configure a QoS profile:
To do...
Enter system view
Create a QoS
profile and enter
QoS profile view
Operation
Use the command...
system-view
qos-profile profile-name
2-2
Chapter 2 QoS Profile Configuration
Description
Required
Optional
—
Required
If the specified QoS
profile already exists, you
enter the QoS profile view
directly.
Remarks