Operation Manual – Information Center
H3C S3100-52P Ethernet Switch
If the character string ends with (l), it indicates the log information
If the character string ends with (t), it indicates the trap information
If the character string ends with (d), it indicates the debugging information
IX. Source
This field indicates the source of the information, such as the source IP address of the
log sender. This field is optional and is displayed only when the output destination is the
log host.
X. Context
This field provides the content of the system information.
1.2 Information Center Configuration
1.2.1 Information Center Configuration Task List
Complete the following tasks to configure information center:
Configuring Synchronous Information Output
Configuring to Display the Time Stamp with the UTC Time Zone
Setting to Output System Information to the Console
Setting to Output System Information to a Monitor Terminal
Setting to Output System Information to a Log Host
Setting to Output System Information to the Trap Buffer
Setting to Output System Information to the Log Buffer
Setting to Output System Information to the SNMP NMS
1.2.2 Configuring Synchronous Information Output
Synchronous information output refers to the feature that if the system information such
as log, trap, or debugging information is output when the user is inputting commands,
the command line prompt (in command editing mode a prompt, or a [Y/N] string in
interaction mode) and the input information are echoed after the output.
This feature is used in the case that your input is interrupted by a large amount of
system output. With this feature enabled, the system echoes your previous input and
you can continue your operations from where you were stopped.
Follow these steps to configure synchronous information output:
Task
1-8
Chapter 1 Information Center
Remarks
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional