Configuring A Static Router Port; Configuring A Port As A Simulated Group Member - H3C S3100-52P Operation Manual

Operation Manual – Multicast
H3C S3100-52P Ethernet Switch
Caution:
You can configure up to 200 static member ports on an S3100-52P switch.
If a port has been configured as a reflect port, it cannot be configured as a static
member port.

3.2.10 Configuring a Static Router Port

In a network where the topology is unlikely to change, you can configure a port on the
switch as a static router port, so that the switch has a static connection to a multicast
router and receives IGMP messages from that router.
I. In Ethernet port view
Follow these steps to configure a static router port in Ethernet port view:
Enter system view
Enter Ethernet port view
Configure the current port
as a static router port
II. In VLAN view
Follow these steps to configure a static router port in VLAN view:
Enter system view
Enter VLAN view
Configure a specified port
as a static router port

3.2.11 Configuring a Port as a Simulated Group Member

Generally, hosts running IGMP respond to the IGMP query messages of the multicast
switch. If hosts fail to respond for some reason, the multicast switch may consider that
To do...
system-view
interface interface-type
interface-number
multicast
static-router-port vlan
vlan-id
To do...
system-view
vlan vlan-id
multicast
static-router-port
interface-type
interface-number
Chapter 3 IGMP Snooping Configuration
Use the command...
Use the command...
3-14
Remarks
—
—
Required
By default, no static router
port is configured.
Remarks
—
—
Required
By default, no static router
port is configured.