H3C S3100-52P Operation Manual page 83

Operation Manual – Login
H3C S3100-52P Ethernet switch
enter the user login authentication page, and enter the main page of the Web-based
network management system after passing the authentication. If no login banner is
configured by the header command, a user logging in through Web directly enters the
user login authentication page.
Follow these steps to configure the login banner:
Enter system view
Configure the banner to
be displayed when a
user logs in through Web
5.3.2 Configuration Example
I. Network requirements
A user logs in to the switch through Web.
The banner page is desired when a user logs into the switch.
II. Network diagram
Figure 5-3 Network diagram for login banner configuration
III. Configuration Procedure
# Enter system view.
<Sysname> system-view
# Configure the banner Welcome to be displayed when a user logs into the switch
through Web.
[Sysname] header login %Welcome%
Assume that a route is available between the user terminal (the PC) and the switch.
After the above-mentioned configuration, if you enter the IP address of the switch in the
address bar of the browser running on the user terminal and press <Enter>, the
browser will display the banner page, as shown in
To do...
system-view
header login text
Chapter 5 Logging In Through the Web-based
Use the command...
Figure
5-3
Network Management System
Remarks
—
Required
By default, no login
banner is configured.
5-4.