Operation Manual – VLAN-VPN
H3C S3100-52P Ethernet Switch
Enabling the VLAN-VPN Feature for a Port
Configuring the TPID Value for VLAN-VPN Packets on a Port
Configuring the Inner-to-Outer Tag Priority Replicating and
Mapping Feature
1.2.2 Enabling the VLAN-VPN Feature for a Port
Follow these steps to enable the VLAN-VPN feature for a port:
Enter system view
Enter Ethernet port
view
Enable the VLAN-VPN
feature on the port
1.2.3 Configuring the TPID Value for VLAN-VPN Packets on a Port
For your device to correctly identify the VLAN tagged frames from the public network,
make sure that the TPID you will use is the same as that used on the peer device in the
public network.
Follow these steps to configure the TPID for VLAN-VPN packets on a port:
Enter system view
Enter Ethernet port
view
Set the TPID value on
the port
To do...
Use the command...
system-view
interface interface-type
interface-number
vlan-vpn enable
To do...
Use the command...
system-view
interface interface-type
interface-number
vlan-vpn tpid value
Task
1-4
Chapter 1 VLAN-VPN Configuration
Remarks
Required
Optional
Optional
Remarks
—
—
Required
By default, the VLAN-VPN
feature is disabled on a port.
Remarks
—
—
Required
Do not set the TPID value to
any of the protocol type
values listed in
Table
For H3C series switches, the
TPID defaults to 0x8100.
1-1.