H3C S3100-52P Operation Manual page 757

Operation Manual – FTP-SFTP-TFTP
H3C S3100-52P Ethernet Switch
the switch configuration file named config.cfg to directory switch of the PC to back up
the configuration file.
Create a user account on the FTP server with the username switch and password
hello, and grant the user switch read and write permissions for the directory
switch on the PC.
Configure the IP address 1.1.1.1 for a VLAN interface on the switch, and 2.2.2.2
for the PC. Ensure a route exists between the switch and the PC.
II. Network diagram
Figure 1-6 Network diagram for FTP configurations: a switch operating as an FTP
client
III. Configuration procedure
1) Configure the PC (FTP server)
Perform FTP server–related configurations on the PC, that is, create a user account on
the FTP server with username switch and password hello. (For detailed configuration,
refer to the configuration instruction relevant to the FTP server software.)
2) Configure the switch (FTP client)
# Log in to the switch. (You can log in to a switch through the Console port or by
telnetting the switch. See the Login module for detailed information.)
<Sysname>
Caution:
If available space on the Flash memory of the switch is not enough to hold the file to be
uploaded, you need to delete files not in use from the Flash memory to make room for
the file, and then upload the file again. The files in use cannot be deleted. If you have to
delete the files in use to make room for the file to be uploaded, you can only
delete/download them through the Boot ROM menu.
# Connect to the FTP server using the ftp command in user view. You need to provide
the IP address of the FTP server, the user name and the password as well to enter FTP
view.
<Sysname> ftp 2.2.2.2
Chapter 1 FTP and SFTP Configuration
1-15