Configuring The Voice Vlan To Operate In Manual Voice Vlan Assignment Mode - H3C S3100-52P Operation Manual

Operation Manual – Voice VLAN
H3C S3100-52P Ethernet Switch
Caution:
A port working in automatic voice VLAN assignment mode cannot be assigned to
the voice VLAN manually. Therefore, if a VLAN is configured as the voice VLAN and
a protocol-based VLAN at the same time, the protocol-based VLAN function cannot
be bound with the port. For information about protocol-based VLANs, refer to VLAN
Configuration in this manual.
For a port operating in automatic voice VLAN assignment mode, its default VLAN
cannot be configured as the voice VLAN; otherwise the system prompts you for
unsuccessful configuration.
Note:
When the voice VLAN is working normally, if the device restarts, in order to make the
established voice connections work normally, the system does not need to be triggered
by the voice traffic to add the port in automatic mode to the voice VLAN but does so
immediately after the restart.
1.2.3 Configuring the Voice VLAN to Operate in Manual Voice VLAN
Assignment Mode
Follow these steps to configure a voice VLAN to operate in manual voice VLAN
assignment mode:
Enter system view
Set an OUI address that can be
identified by the voice VLAN
Enable the voice VLAN security
mode
Set the voice VLAN aging timer
To do...
1-9
Chapter 1 Voice VLAN Configuration
Use the command...
system-view
voice vlan
mac-address oui
mask oui-mask
[ description text ]
voice vlan security
enable
voice vlan aging
minutes
Remarks
—
Optional
Without this
address, the
default OUI
address is used.
Optional
By default, the
voice VLAN
security mode is
enabled.
Optional
The default aging
timer is 1,440
minutes.