H3C S3100-52P Operation Manual page 357

Hide thumbs Also See for S3100-52P:

Table of Contents

Operation Manual – Multicast

H3C S3100-52P Ethernet Switch

II. Network diagram

Figure 3-4 Network diagram for multicast VLAN configuration

III. Configuration procedure

The following configuration is based on the prerequisite that the devices are properly

connected and all the required IP addresses are already configured.

Configure Switch A:

# Set the interface IP address of VLAN 20 to 168.10.1.1 and enable PIM DM on the

VLAN interface.

<SwitchA> system-view

[SwitchA] multicast routing-enable

[SwitchA] vlan 20

[SwitchA–vlan20]port Ethernet 1/0/1

[SwitchA-vlan20] quit

[SwitchA] interface Vlan-interface 20

[SwitchA-Vlan-interface20] ip address 168.10.1.1 255.255.255.0

[SwitchA-Vlan-interface20] pim dm

[SwitchA-Vlan-interface20] quit

# Configure VLAN 10.

[SwitchA] vlan 10

[SwitchA-vlan10] quit

# Define Ethernet 1/0/10 as a hybrid port, add the port to VLAN 10, and configure the

port to forward tagged packets for VLAN 10.

[SwitchA] interface Ethernet 1/0/10

[SwitchA-Ethernet1/0/10] port link-type hybrid

[SwitchA-Ethernet1/0/10] port hybrid vlan 10 tagged

[SwitchA-Ethernet1/0/10] quit

# Configure the interface IP address of VLAN 10 as 168.10.2.1, and enable PIM-DM

[SwitchA] interface Vlan-interface 10

[SwitchA-Vlan-interface10] ip address 168.10.2.1 255.255.255.0

Chapter 3 IGMP Snooping Configuration

Chapters

Table of Contents