Configuring The User Interfaces For Ssh Clients - H3C S3100-52P Operation Manual

Operation Manual – SSH
H3C S3100-52P Ethernet Switch
Note:
The SSH server needs to cooperate with an SSH client to complete the interactions
between them. For SSH client configuration, refer to

1.3.1 Configuring the User Interfaces for SSH Clients

An SSH client accesses the device through a VTY user interface. Therefore, you need
to configure the user interfaces for SSH clients to allow SSH login. Note that the
configuration takes effect at the next login.
Table 1-3 Follow these steps to configure the user interface for SSH clients:
Enter system view
Enter user interface
view of one or more
user interfaces
Configure the
authentication mode
as scheme
Specify the supported
protocol(s)
Caution:
If you have configured a user interface to support SSH protocol, you must configure
AAA authentication for the user interface by using the authentication-mode
scheme command to ensure successful login.
On
authentication-mode none command has been executed, the protocol inbound
ssh command is not available. Similarly, if the protocol inbound ssh command
has
authentication-mode none commands are not available.
To do...
system-view
user-interface vty
first-number [ last-number ]
authentication-mode
scheme
[ command-authorization ]
protocol inbound { all |ssh |
telnet }
a user interface,
been executed,
Use the command...
if the authentication-mode
the authentication-mode
1-7
Chapter 1 SSH Configuration
Configuring the SSH Client.
Remarks
—
—
Required
By default, the user
interface authentication
mode is password.
Optional
By default, both Telnet
and SSH are supported.
password
password
or
and