H3C S3100-52P Operation Manual page 269

Operation Manual – MSTP
H3C S3100-52P Ethernet Switch
If packets in legacy format are received, the port turns to discarding state to
prevent network storm.
I. Configuration procedure
Follow these steps to configure how a port recognizes and sends MSTP packets (in
system view):
Enter system view
Configure how a port
recognizes and sends
MSTP packets
Table 1-7
Follow these steps to configure how a port recognizes and sends MSTP packets (in
Ethernet port view):
Enter system view
Enter Ethernet port view
Configure how a port
recognizes and sends
MSTP packets
II. Configuration example
# Configure Ethernet 1/0/1 to recognize and send packets in dot1s format.
<Sysname> system-view
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] stp compliance dot1s
# Restore the default mode for Ethernet 1/0/1 to recognize/send MSTP packets.
[Sysname-Ethernet1/0/1] undo stp compliance
To do...
system-view
stp interface
interface-type
interface-number
compliance { auto |
dot1s | legacy }
To do...
system-view
interface interface-type
interface-number
stp compliance { auto |
dot1s | legacy }
Use the command...
Use the command...
1-25
Chapter 1 MSTP Configuration
Remarks
—
Required
By default, a port
recognizes and sends
MSTP packets in the
automatic mode. That is, it
determines the format of
packets to be sent
according to the format of
the packets received.
Remarks
—
—
Required
By default, a port
recognizes and sends
MSTP packets in the
automatic mode. That is, it
determines the format of
packets to be sent
according to the format of
the packets received.