H3C S3100-52P Operation Manual page 780

Operation Manual – Information Center
H3C S3100-52P Ethernet Switch
To add UTC time zone to the time stamp in the information center output information,
you must:
Set the local time zone
Set the time stamp format in the output destination of the information center to
date
Configure to add UTC time zone to the output information
After the above configuration, the UTC time zone will be displayed in the output
information, like the following:
%Dec
VTY(1.1.0.2) in unit1 login
III. Sysname
Sysname is the system name of the local switch and defaults to "H3C".
You can use the sysname command to modify the system name. Refer to the System
Maintenance and Debugging part of this manual for details)
Note that there is a space between the sysname and module fields.
IV. %%
This field is a preamble used to identify a vendor. It is displayed only when the output
destination is log host.
V. nn
This field is a version identifier of syslog. It is displayed only when the output destination
is log host.
VI. Module
The module field represents the name of the module that generates system information.
You can enter the info-center source ? command in system view to view the module
list. Refer to
Between "module" and "level" is a "/".
VII. Level (Severity)
System information can be divided into eight levels based on its severity, from 1 to 8.
Refer to
is a forward slash "/" between the level (severity) and digest fields.
VIII. Digest
The digest field is a string of up to 32 characters, outlining the system information.
Note that there is a colon between the digest and content fields.
For system information destined to the log host,
8 10:12:21:708 2006 [GMT+08:00:00] Sysname SHELL/5/LOGIN:- 1 -
Table 1-3 for module name and description.
Table 1-1 for definition and description of these severity levels. Note that there
1-7
Chapter 1 Information Center