H3C S3100-52P Operation Manual page 74

Operation Manual – Login
H3C S3100-52P Ethernet switch
Figure 3-6 Network diagram for Telnet connection establishment
4) Launch Telnet on your PC, with the IP address of VLAN-interface 1 of the switch
as the parameter, as shown in
Figure 3-7 Launch Telnet
5) If the password authentication mode is specified, enter the password when the
Telnet window displays "Login authentication" and prompts for login password.
The CLI prompt (such as <Sysname>) appears if the password is correct. If all
VTY user interfaces of the switch are in use, you will fail to establish the
connection and receive the message that says "All user interfaces are used,
please try later!". A H3C series Ethernet switch can accommodate up to five Telnet
connections at same time.
6) After successfully Telnetting to the switch, you can configure the switch or display
the information about the switch by executing corresponding commands. You can
also type ? at any time for help. Refer to the relevant parts in this manual for the
information about the commands.
Chapter 3 Logging In Through Telnet
Figure 3-7.
3-15