Displaying Hwping Configuration; Hwping Configuration Examples; Icmp Test - H3C S3100-52P Operation Manual

Operation Manual – HWPing
H3C S3100-52P Ethernet Switch
Enable the HWPing client
to send Trap messages
Configure the number of
consecutive unsuccessful
HWPing tests before Trap
output
Configure the number of
consecutive unsuccessful
HWPing probes before
Trap output

1.2.3 Displaying HWPing Configuration

Display test history
Display the results of the
latest test

1.3 HWPing Configuration Examples

1.3.1 ICMP Test

I. Network requirements
An H3C S3100-52P Ethernet switch serves as the HWPing client. A HWPing ICMP test
between the switch and another switch uses ICMP to test the round trip time (RTT) for
packets generated by the HWPing client to travel to and back from the destination
switch.
II. Network diagram
Figure 1-2 Network diagram for the ICMP test
To do...
send-trap { all |
{ probefailure |
testcomplete |
testfailure }* }
test-failtimes times
probe-failtimes times
To do...
display hwping history
[ administrator-name operation-tag ]
display hwping results
[ administrator-name operation-tag ]
Use the command...
Use the command...
1-19
Chapter 1 HWPing Configuration
Remarks
Required
By default, Trap sending
is disabled.
Optional
By default, Trap
messages are sent each
time a test fails.
Optional
By default, Trap
messages are sent each
time a probe fails.
Remarks
Available in any
view.