H3C S3100-52P Operation Manual page 71

Operation Manual – Login
H3C S3100-52P Ethernet switch
Authenticati
on mode
Note:
Refer to AAA Operation and SSH Operation of this manual for information about AAA,
RADIUS, and SSH.
3.4.2 Configuration Example
I. Network requirements
Assume current user logins through the console port and the user level is set to the
administrator level (level 3). Perform the following configurations for users logging in to
VTY 0 using Telnet.
Configure the local user name as guest.
Set the authentication password of the local user to 123456 (in plain text).
Set the service type of VTY users to Telnet and the command level to 2.
Configure to authenticate users logging in to VTY 0 in scheme mode.
Only Telnet protocol is supported in VTY 0.
The screen can contain up to 30 lines.
The history command buffer can store up to 20 commands.
The timeout time of VTY 0 is 6 minutes.
Scenario
User type
The user privilege level level
command is not executed, and
the service-type command does
not specify the available
command level.
The user privilege level level
command is not executed, and
VTY users that
the service-type command
are
specifies the available command
authenticated
level.
in the
The user privilege level level
password
command is executed, and the
mode of SSH
service-type command does not
specify the available command
level.
The user privilege level level
command is executed, and the
service-type command specifies
the available command level.
3-12
Chapter 3 Logging In Through Telnet
Command
Command
level
Level 0
Determined
by the
service-type
command
Level 0
Determined
by the
service-type
command