Chapter 2 Ipv6 Application Configuration; Introduction To Ipv6 Application; Configuring Ipv6 Application; Ipv6 Ping - H3C S3100-52P Operation Manual

Operation Manual – IPv6 Management
H3C S3100-52P Ethernet Switch

Chapter 2 IPv6 Application Configuration

When configuring IPv6 application, go to these sections for information you are
interested in:

Introduction to IPv6 Application

Configuring IPv6 Application

IPv6 Application Configuration Example
Troubleshooting IPv6 Application
2.1 Introduction to IPv6 Application
IPv6 are supporting more and more applications. Most of IPv6 applications are the
same as those of IPv4. The applications supported on H3C S3100-52P Ethernet Switch
are:
Ping
Traceroute
TFTP
Telnet
2.2 Configuring IPv6 Application

2.2.1 IPv6 Ping

The ping ipv6 command is commonly used for testing the reachability of a host. This
command sends an ICMPv6 message to the destination host and records the time for
the response message to be received. For details about the ping command, refer to
System Maintenance and Debugging Operation in this manual.
After you execute the ping ipv6 command, you can press Ctrl+C to terminate the ping
operation.
Follow these steps to ping IPv6:
To do...
Ping IPv6
Use the command...
ping ipv6 [ -a source-ipv6 | -c
count | -m interval | -s packet-size |
-t timeout ]* remote-system [ -i
interface-type interface-number ]
2-1
Chapter 2 IPv6 Application Configuration
Remarks
Required
Available in any view