Ftp Test - H3C S3100-52P Operation Manual

Operation Manual – HWPing
H3C S3100-52P Ethernet Switch
Note:
You can perform a HWPing DHCP test only when no DHCP client is enabled on any
interface. Otherwise, the DHCP Server sends the response to an interface enabled
with the DHCP Client rather than to the source interface, thus resulting in HWPing
DHCP test failure.

1.3.3 FTP Test

I. Network requirements
Both the HWPing client and the FTP server are H3C S3100-52P Ethernet switches.
Perform a HWPing FTP test between the two switches to test the connectivity to the
specified FTP server and the time required to upload a file to the server after the
connection is established. Both the username and password used to log in to the FTP
server are admin. The file to be uploaded to the server is cmdtree.txt.
II. Network diagram
Figure 1-4 Network diagram for the FTP test
III. Configuration procedure
Configure FTP Server (Switch B):
Configure FTP server on Switch B. For specific configuration of FTP server, refer to the
FTP-SFTP-TFTP part of the manual.
Configure HWPing Client (Switch A):
# Enable the HWPing client.
<Sysname> system-view
[Sysname] hwping-agent enable
# Create a HWPing test group, setting the administrator name to administrator and
test tag to FTP.
[Sysname] hwping administrator ftp
# Configure the test type as ftp.
[Sysname-hwping-administrator-ftp] test-type ftp
# Configure the IP address of the FTP server as 10.2.2.2.
Chapter 1 HWPing Configuration
1-23