Ftp Banner Display Configuration Example - H3C S3100-52P Operation Manual

Operation Manual – FTP-SFTP-TFTP
H3C S3100-52P Ethernet Switch
Caution:
If available space on the Flash memory of the switch is not enough to hold the file to
be uploaded, you need to delete files not in use from the Flash memory to make
room for the file, and then upload the file again. The files in use cannot be deleted. If
you have to delete the files in use to make room for the file to be uploaded, you can
only delete/download them through the Boot ROM menu.
H3C series switch is not shipped with FTP client application software. You need to
purchase and install it by yourself.
3) Configure Switch A (FTP server)
# After uploading the application, use the boot boot-loader command to specify the
uploaded file (switch.bin) to be the startup file used when the switch starts the next
time, and restart the switch. Thus the switch application is upgraded.
<Sysname> boot boot-loader switch.bin
<Sysname> reboot
Note:
For information about the boot boot-loader command and how to specify the startup
file for a switch, refer to the System Maintenance and Debugging part of this manual.

1.2.4 FTP Banner Display Configuration Example

I. Network requirements
Configure the Ethernet switch as an FTP server and the remote PC as an FTP client.
After a connection between the FTP client and the FTP server is established and login
succeeds, the banner is displayed on the FTP client.
An FTP user with username switch and the password hello has been configured
on the FTP server.
The IP addresses 1.1.1.1 for a VLAN interface on the switch and 2.2.2.2 for the PC
have been configured. Ensure that a route exists between the switch and the PC.
Configure the login banner of the switch as "login banner appears" and the shell
banner as "shell banner appears".
Chapter 1 FTP and SFTP Configuration
1-13