Ipv6 Application Configuration Example; Ipv6 Applications - H3C S3100-52P Operation Manual

Operation Manual – IPv6 Management
H3C S3100-52P Ethernet Switch
Figure 2-2 Provide Telnet services
I. Configuration prerequisites
Enable Telnet on the Telnet server and configure the authentication method. For details,
refer to Login Operation in this manual.
Follow these steps to set up IPv6 Telnet connections:
Perform the telnet
command on the Telnet
client to log in to other
devices
Caution:
When you use the telnet ipv6 command to connect to the Telnet server, you must
specify the "–i" keyword if the destination address is a link-local address.
II. Displaying and maintaining IPv6 Telnet
Display the use
information of the users
who have logged in

2.3 IPv6 Application Configuration Example

2.3.1 IPv6 Applications

I. Network requirements
In Figure
S3100-52P Ethernet switch, SWB and SWC are two switches supporting IPv6
forwarding. In a LAN, there is a Telnet server and a TFTP server for providing Telnet
To do...
telnet ipv6
remote-system [ -i
interface-type
interface-number ]
[ port-number ]
To do...
display users [ all ]
2-3, SWA, SWB, and SWC are three switches, among which SWA is an H3C
Chapter 2 IPv6 Application Configuration
Use the command...
Use the command...
2-4
Remarks
Required
Available in user view
Remarks
Available in any view