Configuring Client Version Checking - H3C S3100-52P Operation Manual

Operation Manual – 802.1x and System Guard
H3C S3100-52P Ethernet switch
Note:
The proxy checking function needs the cooperation of H3C's 802.1x client (iNode)
program.
The proxy checking function depends on the online user handshaking function. To
enable the proxy detecting function, you need to enable the online user
handshaking function first.
The configuration listed in the above table takes effect only when it is performed on
CAMS as well as on the switch. In addition, the client version checking function
needs to be enabled on the switch too (by using the dot1x version-check
command).

1.4.2 Configuring Client Version Checking

Follow these steps to configure client version checking:
To do...
Enter system view
Enable
802.1x
client
version
checking
Set the maximum
number of retires to
send version
checking request
packets
Set the client version
checking period timer
To do... Use the command...
quit
Use the command...
system-view
In
dot1x version-check
system
[ interface interface-list ]
view
interface interface-type
interface-number
In port
view
dot1x version-check
quit
dot1x retry-version-max
max-retry-version-value
dot1x timer ver-period
ver-period-value
—
Required
By default, 802.1x client
version checking is disabled
on a port.
Optional
By default, the maximum
number of retires to send
version checking request
packets is 3.
Optional
By default, the timer is set to
30 seconds.
1-21
Chapter 1 802.1x Configuration
Remarks
Remarks