Configuring Vlan Mapping - H3C S3100-52P Operation Manual

Operation Manual – QoS-QoS Profile
H3C S3100-52P Ethernet Switch
Note:
Packets redirected to the CPU are not forwarded.
If the traffic is redirected to a Combo port in down state, the system automatically
redirects the traffic to the port corresponding to the Combo port in up state. Refer to
the Port Basic Configuration module of this manual for information about Combo
ports.
If the traffic is configured to be redirected to an aggregation group, the traffic is
redirected to the master port of the aggregation group. Refer to the Link Aggregation
module of this manual for information about aggregation group.
When the traffic redirecting function is used in conjunction with the selective QinQ
function, you can specify the untagged keyword as required (that is, remove the
outer VLAN tag of a packet after the packet is redirected to the uplink port) in a tree
network with a single uplink port (or an aggregation group). Do not specify the
untagged keyword in a ring network or a network with multiple uplink ports. Refer to
the VLAN-VPN module of this manual for information about selective QinQ.
III. Configuration example
Ethernet 1/0/1 is connected to the 10.1.1.0/24 network segment.
Redirect all the packets from the 10.1.1.0/24 network segment to Ethernet 1/0/7.
Configuration procedure:
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.0 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] traffic-redirect inbound ip-group 2000 interface
Ethernet1/0/7

1.4.8 Configuring VLAN Mapping

Refer to section
I. Configuration prerequisites
The ACL rules used for traffic classification have been defined. Refer to the ACL
module of this manual for information about defining ACL rules.
The ports on which the configuration is to be performed have been determined.
The VLAN ID to be set for the packets has been determined.
II. Configuration procedure
Follow these steps to configure VLAN mapping:
VLAN Mapping for information about VLAN mapping.
1-25
Chapter 1 QoS Configuration