Setting To Output System Information To The Snmp Nms; Displaying And Maintaining Information Center - H3C S3100-52P Operation Manual

Operation Manual – Information Center
H3C S3100-52P Ethernet Switch
Set the format of time
stamp in the output
information

1.2.9 Setting to Output System Information to the SNMP NMS

Follow these steps to set to output system information to the SNMP NMS:
Enter system view
Enable the information
center
Enable information output
to the SNMP NMS
Configure the output rules
of system information
Set the format of time
stamp in the output
information
Note:
To send information to a remote SNMP NMS properly, related configurations are
required on both the switch and the SNMP NMS.

1.3 Displaying and Maintaining Information Center

Display information on an
information channel
To do...
info-center timestamp
{ log | trap | debugging }
{ boot | date | none }
To do...
system-view
info-center enable
info-center snmp
channel
{ channel-number |
channel-name }
info-center source
{ modu-name | default }
channel
{ channel-number |
channel-name } [ { log |
trap | debug } { level
severity | state state } ]*
info-center timestamp
{ log | trap | debugging }
{ boot | date | none }
To do...
display channel
[ channel-number |
channel-name ]
Use the command...
Use the command...
Use the command...
1-16
Chapter 1 Information Center
Remarks
Optional
By default, the time stamp
format of the output log
information is date.
Remarks
—
Optional
Enabled by default.
Optional
By default, the switch
outputs trap information to
SNMP through channel 5.
Optional
Refer to Table 1-4 for the
default output rules of
system information.
Optional
By default, the time stamp
format of the information
output to the SNMP NMS
is date.
Remarks
Available in any
view