Configuring Queue Scheduling - H3C S3100-52P Operation Manual

Operation Manual – QoS-QoS Profile
H3C S3100-52P Ethernet Switch
To do...
Enter system view
Enter Ethernet port
view
Configure VLAN
mapping

1.4.9 Configuring Queue Scheduling

Refer to section
I. Configuration prerequisites
The algorithm for queue scheduling to be used and the related parameters have been
determined.
II. Configuration procedure
Follow these steps to configure queue scheduling in system view:
To do...
Enter system view
Configure queue
scheduling
Follow these steps to configure queue scheduling in Ethernet port view:
To do...
Enter system view
Enter Ethernet port
view
Use the command...
system-view
interface interface-type
interface-number
traffic-remark-vlanid
inbound acl-rule
remark-vlan remark-vlanid
Queue Scheduling for information about queue scheduling.
Use the command...
system-view
queue-scheduler
{ strict-priority | wfq
queue0-width queue1-width
queue2-width queue3-width
queue4-width queue5-width
queue6-width queue7-width | wrr
queue0-weight queue1-weight
queue2-weight queue3-weight
queue4-weight queue5-weight
queue6-weight queue7-weight }
Use the command...
system-view
interface interface-type
interface-number
1-26
Chapter 1 QoS Configuration
Remarks
—
—
Required
By default, VLAN mapping
is not configured.
Remarks
—
Required
By default, the queue
scheduling algorithm
adopted on all the ports is
WRR. The default
weights of the eight output
queues of a port are 1, 2,
3, 4, 5, 9, 13, and 15 (in
the order queue 0 through
queue 7).
Remarks
—
—