H3C S3100-52P Operation Manual page 710

Operation Manual – SSH
H3C S3100-52P Ethernet Switch
II. Network diagram
Figure 1-13 Switch acts as server for password and RADIUS authentication
III. Configuration procedure
1) Configure the RADIUS server
Note:
This document takes CAMS Version 2.10 as an example to show the basic RADIUS
server configurations required.
# Add an access device.
Log into the CAMS management platform and select System Management > System
Configuration from the navigation tree. In the System Configuration window, click
Modify of the Access Device item, and then click Add to enter the Add Access
Device window and perform the following configurations:
Specify the IP address of the switch as 192.168.1.70.
Set both the shared keys for authentication and accounting packets to expert.
Select LAN Access Service as the service type.
Specify the ports for authentication and accounting as 1812 and 1813
respectively.
Select Extensible Protocol as the protocol type.
Select Standard as the RADIUS packet type.
1-31
Chapter 1 SSH Configuration