Setting To Output System Information To A Log Host - H3C S3100-52P Operation Manual

Operation Manual – Information Center
H3C S3100-52P Ethernet Switch
Note:
When there are multiple Telnet users or dumb terminal users, they share some
configuration parameters including module filter, language and severity level
threshold. In this case, change to any such parameter made by one user will also be
reflected on all other user terminals.
To view debugging information of specific modules, you need to set the information
type as debug when setting the system information output rules, and enable
debugging for corresponding modules through the debugging command.
II. Enabling system information display on a monitor terminal
After setting to output system information to a monitor terminal, you need to enable the
associated display function in order to display the output information on the monitor
terminal.
Follow these steps to enable the display of system information on a monitor terminal:
Enable the
debugging/log/trap
information terminal
display function
Enable debugging
information terminal
display function
Enable log information
terminal display function
Enable trap information
terminal display function
Note:
Make sure that the debugging/log/trap information terminal display function is enabled
(use the terminal monitor command) before you enable the corresponding terminal
display function by using the terminal debugging, terminal logging, or terminal
trapping command.

1.2.6 Setting to Output System Information to a Log Host

Follow these steps to set to output system information to a log host:
To do...
terminal monitor
terminal debugging
terminal logging
terminal trapping
Use the command...
1-13
Chapter 1 Information Center
Remarks
Optional
Enabled by default
Optional
Disabled by default
Optional
Enabled by default
Optional
Enabled by default