Hwping Server Configuration; Hwping Client Configuration - H3C S3100-52P Operation Manual

Operation Manual – HWPing
H3C S3100-52P Ethernet Switch
1.2 HWPing Configuration
The TCP/UDP/jitter tests need the cooperation of HWPing client and HWPing server.
Other types of tests need to configure HWPing client and corresponding different
servers.
You can enable both the HWPing client and HWPing server functions on an H3C
S3100-52P Ethernet switch, that is, the switch can serve as a HWPing client and server
simultaneously.

1.2.1 HWPing Server Configuration

The following table describes the configuration on HWPing server, which is the same
for HWPing test types that need to configure HWPing server.
Follow these steps to perform HWPing server configurations:
Enter system view
Enable the HWPing
server function
Configure a UDP listening
service
Configure a TCP listening
service
Note that:
The HWPing server function is needed only for jitter, TCP, and UDP tests.
You can configure multiple TCP/UDP listening services on one HWPing server,
with each listening service corresponding to a specific destination IP address and
port number.

1.2.2 HWPing Client Configuration

I. HWPing client configuration
After HWPing client is enabled, you can create multiple test groups for different tests,
without the need to enable HWPing client repeatedly for each test group.
To do...
system-view
hwping-server enable
hwping-server udpecho
ip-address port-num
hwping-server
tcpconnect ip-address
port-num
Use the command...
1-5
Chapter 1 HWPing Configuration
Remarks
—
Required
Disabled by default.
Required for UDP and
jitter tests
By default, no UDP
listening service is
configured.
Required for TCP tests
By default, no TCP
listening service is
configured.