Chapter 2 Selective Qinq Configuration Commands; Selective Qinq Configuration Commands; Mac-Address-Mapping - H3C S3100-52P Command Manual

Command Manual – VLAN-VPN
H3C S3100-52P Ethernet Switch
Chapter 2 Selective QinQ Configuration
Note:
The selective QinQ feature is new to H3C S3100-52P Ethernet Switch.

2.1 Selective QinQ Configuration Commands

2.1.1 mac-address-mapping

Syntax
mac-address-mapping
dest-vlan-id
undo mac-address-mapping { index | all }
View
Ethernet port view
Parameters
index: Index of the inter-VLAN MAC address replicating configuration to be created or
removed. This argument is in the range 0 to 7.
source-vlan source-vlan-list: Specifies a list of the IDs of the VLANs, whose MAC
address entries are to be replicated to the MAC address table of the destination VLAN.
You need to provide the source-vlan-list argument in the form of { vlan-id [ to
vlan-id ] }&<1-10>, where the VLAN ID after the to keyword must be larger than or
equal to the VLAN ID before the to keyword and &<1-10> means that you can specify
up to 10 VLANs/VLAN ranges for this argument.
dest-vlan-id: ID of the destination VLAN for replication, in the range 1 to 4094.
all: Removes all the inter-VLAN MAC address replicating configurations created on the
current port.
Description
Use the mac-address-mapping command to configure the inter-VLAN MAC address
replicating feature for a port. This feature can replicate MAC address entries of the

Chapter 2 Selective QinQ Configuration Commands

Commands
index source-vlan
2-1
source-vlan-list destination-vlan